Before you venture into local basement waterproofing, you should comprehend why it might be damp in the first place. Since most basements in NYC are below the ground, they are more horizontal to gather excess moisture and suffering water damage.
Common Reasons of Wet Basement:
- Poor drainage is a major cause of a wet basement. When flooded water not correctly directed away from your home, it will sit at the house’s basement and seep into the basement.
- Improperly installed or blocked gutters or even sloping around your home is distressing. If your land has sloped toward your home, water will run toward and collect around your house’s basement.
- Cracks in a house’s basement are a definite way for water to dribble in through your basement walls and floors.
- The doors, windows, and wells of basement that aren’t secure are other ways for water leakage.
The basement is said to be the main part of any home. But as a basement of a house shifts and settles into the earth, cracks will inevitably develop and water can seep in, resulting in a wet basement.
Typically, these cracks can be fixed with simple basement waterproofing solutions. There are a few possible interior and exterior waterproofing cases where a contractor required to repair major basement damages, or a hired professional would recommend remodeling your waterproof system.
Though, here, we’ll focus on what you, as an owner, can do for interior waterproofing.
Before Starting
Before you start basement waterproofing from walls, you want to know from where your water is coming.
Sometimes the cause of your basement problems is apparent, such as detectable water striped coming down from windows, walls, or around pipes.
But if a whole concrete wall considers damp, tumble a large part, tape an open area foot piece of foil over that stain, and check for a reduction on the inside of the foil after a day.
If the foil is damp, it is likely that you have water seeping in through your basement walls. If the foil is dry, the water is beginning away, and you’ll need to inspect further.
1: Clean the Affected Area
First, you have to clean up the areas you are going to be waterproof. Many of the waterproofing methods can be used directly to the substrate. So, if there are any existing coatings on the surface, wall, or floor, they should remove.
2: Block the Holes
For any holes, use hydraulic cement to block any visible holes and large cracks. Hydraulic cement seals the cracks and holes in masonry and stops water flow through them, even under pressure.
3: Fill out the Cracks
After blocking the holes, it’s time to fill out small cracks with masonry crack filler.
4: Seal Openings
Through caulking doors, windows, and window walls can be sealed. The elastic sealant, such as Big Stretch Sealant or Lexel Sealant, both are waterproofing substances and flexible in use.
5: Apply Waterproof Coating
After the cracks and holes sealed, use a waterproof coating on your basement exterior. Apply the concrete sealer and make sure to work it into the pores of the masonry.
Proper coverage and a minimum of two coats must required to guarantee waterproofing.
Reading all the points, one may consider handling basement waterproofing. But a professional waterproofing contractor makes this hassle simpler.
Melange Restoration Inc. waterproofing contractors presenting professional services in all major areas of NYC, such as Bronx, Brooklyn, Queens, and Manhattan. To get more updates and success stories of Melange Restoration Inc. follow our social links of Facebook, Instagram, and LinkedIn.
